Installation Instructions

Surface should be approximately 10 degrees celsius or above for best adhesion. Outdoor application is not advised in colder temperatures as the adhesive will only set in warmer temperatures.  

Step 1

Clean the area thoroughly with rubbing alcohol or soap and water. It is advised to not use glass cleaner as it will leave a residue behind that will prevent the decal from adhering well or reduce the life of the decal.

Step 2

Prepare the sticker for application by firmly rubbing a squeegee or credit card across the  transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.

Step 3

Peel the white paper backing off the decal. If the decal stays on the backing, slowly replace the paper backing and repeat Step 2. (You should only be left with the transfer tape and vinyl decal)

Step 4

Slowly lower the decal and transfer tape onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 24 hours before moving to the next step.

Step 5 

Slowly peel the transfer tape off at a sharp angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.